Brooklyn Aquarium Society - Public Forum

Brooklyn Aquarium Society - Public Forum (http://forum.brooklynaquariumsociety.org/index.php)
-   Equipment (http://forum.brooklynaquariumsociety.org/forumdisplay.php?f=19)
-   -   broken center brace on 55 gal (http://forum.brooklynaquariumsociety.org/showthread.php?t=1708)

Dance Myth February 16th, 2014 01:59 PM

broken center brace on 55 gal
 
Any thoughts about a broken center brace?

Its been slowly separating from the back and now its detached. I was going to reattach it with plexiglass and epoxy but when I cut the plexi I noticed there's a quarter inch difference in width between the side where I took the measurement and the center where the brace is which tells me there's some bowing.

I put a pipe clamp on for my peace of mind but can the tank be salvaged?

thanks, Dan Smith

dsuperman February 16th, 2014 08:30 PM

I had the same prob. with a 55gal. in my workplace maybe ten years ago.We used a whole tube of two part plastic epoxy and clamped it. Removed the clamp after a few days and it held fine, i think its still there holding up fine.

Dance Myth February 16th, 2014 08:53 PM

That's what I'm doing now. Epoxy on the plastic edge and putting a piece of plexi underneath the whole area.

thanks for getting back to me.

Dan Smith

john fox February 16th, 2014 11:06 PM

I think the tank is built like that so you can put the glass covers On it , 1 0n each side but a 2 part epoxy should do the trick

Dance Myth February 17th, 2014 10:49 AM

Thanks for the advice but the repair didn't hold. Time to get that 90 gallon I've been dreaming of.

john fox February 17th, 2014 10:54 AM

Just a thought , the club has a 55 up for auction the starting bid was 25$ it is in storage I paid 95 $ for mine if interested get in touch with Steve or joe.

stevem February 17th, 2014 08:45 PM

Broken Brace
 
I have fixed a few over the years, and the only good way to fix that is with glass
you need a piece of glass about 4" wide by 1/16 " less then the space between the 2 glass walls
So if the space between the front and back glass is let say 13" then u cut the glass 12 15/16"
just so there a little room for the silicone, glue it and tape it so it drys in place.
It has to be thick not 1/8 "
i like to use 3/8" u might get away with 1/4" but i would try for 3/8"
and u have to use aquarium silicone, let it dry for atleast 3 days to fully cure and that will hold.


All times are GMT -4. The time now is 11:09 AM.

Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.

Page generated in 0.02788 seconds with 10 queries